ST-LINK V2 STM8 STM32 – LOAD FIRMWARE TO DISPLAY OR CONTROLLER
ST-Link v2 stm8 stm32 is a programmer/debugger built by ST Microelectronics that allows programming and debugging the STM8 and STM32 processors. The ST-Link v2 implements SWIM (Single Wire Interface Module) and JTAG/SWD (Serial Wire Debugging) to communicate with the development board processors.
For flasher control unit of scooter such as xiaomi, etc.
- 【ST-Link V2】 Emulator downloader programming. Supports full range of SWD STM32 debug interface; Supports full range of STM8 SWIM download debugging (common development environments such as IAR, STVD, etc. are supported); Supports automatic firmware upgrades.
- 【Clear interface definition 4-wire interface (including power supply), wiring is very simple because the interface definition is marked directly on the aluminum housing. ① RST; ②SWDIO③GND④GND⑤SWIM⑥SWICK⑦3.3V⑧3.3V⑨5.0V⑩5.0V.
- 【Supported software versions】. Utility ST-LINK Utility 2.0 and higher; ② STVD and higher; ③ STVP 3.2.3 and higher; ④ IAR EWARM V6.20 and higher; ⑤IAR EWSTM8 V1.30 and higher; ⑥ KEIL RVMDK V4.21 and higher.
- It is convenient and practical, high speed and stable. ① Increased 5V power output, the output I/O ports are protected for fear of operational errors caused by damage ST-LINK V2; BoardThe internal board of this programmer has a 500MA self-recovery fuse, it can protect your computer’s motherboard.
- User-friendly interface, 2.54 seat pitch horns, 20 cm DuPont line, line can respond to different target sequences, flexible wiring
- A video tutorial can be found on youtube.
Other electrical spare parts
